The Engineering tool can be opened in the BLX solution builder and used to create the solutions that containts the configuration for Blendexpert Mill.
The Solution builder is opened and the Engineering tool file is loaded by clicking file and browsing to the right file. A validation is done and if problems is enountered then it will be listed under the validation tab. If there are no problems then each point under the Data tab will get a check mark and is ready to be used.
All the solution files can be see under the preview tab.
This gives a good overview of the files and the file structure.
When ready to the the Generate solution tab and clikc on generate solutions. 4 solution files are now generated and saved under the file paht defined in the engineering tool (
BLX Engineering Tool: Variables)
The files are now ready to be imported into QCX.
Remember to import
in the correct order:
- Base (only import if no previous QCX system)
- Specific
- HMI
- Reports