A short descripion on how to remove a module from a running BLX system.
1) do a backup and store it in a safe location in case something goes wrong.
2) if working on a system with a robolab then make sure not to set system into maintenance without warning operators. Else use the halt function in BLX to stop the system.3) In workplace: Open system --> configuration --> configuration --> BLX
4) select right BLX Specific solution
There are several places where the module/target needs to be removed before it will work:
A)
Controller - ControllerValue: Delete the module/target (there are 3 intances) - SAVE
B)
Raw Materials: Delete the module/target for all raw materials one at the time. Save after the last one else it will not save
C)
Subsections TrendableOutputs for each Subsection: Delete all instances of the module target (Mergers, Mill, Samplers (also under
Sampler Dataitems), silo) SAVE
D)
PlantSecion - Recipes - Targets & Constraints: Delete here
E) PlantSection - Targetorder: Delete Here. SAVE
Go to: Operation mode
Open BLX and do a refresh. Now all instances of the module/target should be gone.
Do a Recalculation to check that BLX is still working.