How to set up Import DRiver to QCX and BLX

Modified on 2019/10/31 13:35 by MKR Categorized as Uncategorized

The import driver takes an analysis from a shared folder and imports it into QCX.




'''Also use the Import driver manual (can be found on FLSadev or on the help on the QCX server)'''


Steps on setup:
# Run the QCX.driver msi file and select Import driver to be installed on hard drive.
# Use the Standard2Solution to convert the standard to a solution file
# Import the solution to QCX
# Set up the QCX lab (see: How to set up Manual Lab with XRF). Call it something with Import instead.
# Under Equipment for the Laboratory Cell only add the Offline equipment.See image 1:




[image:{UP(How-to-set-up-Import-DRiver-to-QCX-and-BLX)}Importdriver1.png|medium|left|Image 1: QCX Lab setup and added equipment]
















Set up the required Sample point and Material type in QCX Lab Editor and select the Laboratory and Remember to select: Recipe Management (Image 2)


[image:{UP(How-to-set-up-Import-DRiver-to-QCX-and-BLX)}Importdriver2.png|medium|left]
















In '''QCX recipe editor''' use the pre-configured Manual recipe. In Selection: set required sample point and material type for the manual recipe.


(Image 3)


[image:{UP(How-to-set-up-Import-DRiver-to-QCX-and-BLX)}importdriver3.png|medium|left|Image 3: Selection of Recipe to requested sample point and material type]

















'''Under Program:''' Edited the default program under Offline Procedure and Equipment to include all the data items and derived items needed (Image 4)


[image:{UP(How-to-set-up-Import-DRiver-to-QCX-and-BLX)}Importdriver4.png|medium|left|Image 4: Set up default program in QCX recipe editor]
















'''Go to QCX Equipment driver'''
# In the driver Specific xml file do the following corrections.
# Activate the right personality – here in this example: Bruker
# Set Preparation, Procudure and Equipment as in example below.
# If connected to a sample taken signal set SampleTakenPolicy to: -2 , else set to -1. Read also manual on Import driver for other settings
# Set filepath for the shared folder.
# Insert MethodId (see from exported XRF file)
# Make sure all the data items needed for QCX are defined in the specific xml file.




[image:{UP(How-to-set-up-Import-DRiver-to-QCX-and-BLX)}importdriver5.png|medium|left|Image 5: Import Driver Specific xml fil]

Meta Keywords:
Meta Description:
Change Comment:

FLSmidth QCX wiki

How to set up Import DRiver to QCX and BLX